Please give a support by clicking on the social buttons below. This article was prepared for you by Christian Robert Adzic from Novi Knezevac-Serbia Also as far as I can find there is no way to downgrade/rollback the firmware to make it easier to make refilling possible.
The repairing was done and the customer was very happy. The CLP310 series (CLP 310/315/325,CLX 3170/3175) and Samsung printers in general discourage/disallow refilling with their firmware updates. Glued it together with a double sided duck tape on the back side of the pcb so I got some extra mm of thickness.Īfter that I glued back to the toner and now it was aligned! Now when I closed the door there were no more light goes On and the error light was off. The best way is probably to get a toner refill kit. Cost is about 20-25 for the chip or you can get a kit with chip and toner for about 60. I bought one for my CLP-310, and it worked just fine.
I cut a piece of cardboard so it fit the dimension of the pcb. Yes, you can buy a reset chip from Ebay that you solder onto the motherboard after removing a chip (depends on which version of reset chip you get).
When I aligned the chips and close the door I had to push the door to make a contact. So I decided to do the followings: The printer then will shows an error message.Īnother big problem, the chips was to inserted too deep into the toner case. If this is not alligned then the contact can’t be made with the reader electronic and the chip could not be read. The vertical red lines are the position where the white arrows should be alligned on the toners. All the chip’s on the toner’s was missaligned and the toners was not original from Samsung. When I opened the front door I saw a huge problem. I decided to check the toners and all the stuff which is in charge to read the condition of the toner. A customer brought to me a Samsung CLP-315 color laser printer with the problem “ the printer refuse to use the new installed toners.” The problem is specific because sometimes all the control lights were On and sometimes only one or two lights would be turning On and off. This was a bit strange to me and I decided to try repair the printer.